Tips

There is no point in reading this page without reading the tutorial first, please read the tutorial first!!!!

Download Reborn Software

• It is recommended to download from Steam, here is the corresponding link. If you are not familiar with Steam, it is recommended to use a search engine to learn about it.
• You can also download from the official website, but the official website version may be updated relatively late. Here is the official website link

Open Rebocap and Complete Motion Calibration

Open Reborn Software

[warning]Steam users must open Reborn in PC mode, not in VR mode!!!

Follow the steps below to connect motion capture

• After opening the software, log in and enter the default scene
• Press ESC on the keyboard to bring up the menu, then press the tab key on the keyboard to switch the view, then hover the mouse to the upper right corner to pop up a right-side panel

  Currently, if the reborn window is minimized or narrowed, the right-side hover button may disappear

• You can reselect the scene

  It is recommended to enter the motion capture scene or dance room for the first time

• Select a character

  Some characters are uploaded by users, and there may be issues with skeleton binding. It is recommended to use the robot model for testing first

• Move the mouse to the upper right hover button, and select connect in the pop-up window

  Note, if the port number of rebocap changes, you also need to modify the connection port number here

In the video below, the middle top position corresponds to the mouse and keyboard operations, including the ESC and TAB keys. Pay attention!

[info]Notes!!!

If you find the character floating in the air or falling into the ground, you can disconnect and then reconnect to open it again